Please connect the white wires from the heater pad to the two bare wires in red sleeve from the controller.
As for the sensor, you may use the one from the controller and attach the sensor probe to the heater surface or the aluminum plate with silicone RTV sealant.
Or, if your Keenovo heater comes with a surface mount sensor (thermistor), you can use the sensor from the heater pad ( red wires) for the controlling. In this case, please cut the black sensor wire in the middle and connect the red wires to the black wires.
There is no polarity for the red, black or white wires.
So as long as they are well connected as instructed above, everything shall work well.
We suggest using mating connectors for the connection so you can swap sensor or heater pad easily for the controller.
I’m a store in need of 100 to 120, 100 X 150mm, 12V 120W, can I get in contact with you for bulk prices?
Thanks
Steve
what power wire gauge should i choose the connector Thanks Tram
Hello, Do I need a separate digital controller for each heating pad or can I wire two pads to one controller? As an example, side bending and waist bending pads wired to one controller.
Hi John,
Please kindly check if the controller’s “HC” value is set back to “H” after your configurated temperature display from Celsius to F.
Used my heat blanket and digital controller for the first time. It worked fine but the temp was difficult to set at one temp. I want to set it to 300F . Any sugestions?